Push Type Internal Tube Cutters -
|Features of Tube Cutters 'ATP' Series
POWERMASTER “Push Type”
Internal Tube Cutters quickly cut through the
walls of ferrous tubes in Condensers and Heat
Exchangers as a step in their removal from the
This sturdy “Push Type”
Internal Tube Cutters can be used with a portable
Electric or Air Drill Motor.
“Push Type” Tube Cutters are
simple to operate. Merely insert it into the tube,
apply power, press inward and the tube can be cut
in a few seconds. Releasing of inward pressure
automatically retracts the Cutters Bit. This Tube Cutter
is equipped with an adjustable collar suitable for
reaching into tubes at various depths.
The replaceable cutting bit can
be interchanged in a few seconds. Standard
adjustable reach is 4”(101.6mm) and they are
available in optional increments of 2”(50.8mm).
“A” reach = 6”(152.4mm). “B” reach = 8”(203.2mm).
“C” reach = 10”(254.0mm) etc.
All Tube Cutters come with a
complete set of pilots covering the entire range
of tube thickness for a particular tube O.D.
(ATP-625 tube cutters come with a built in pilot
suitable for one tube ID only.)
All Cutters are available for MM tube sizes also.
|Sizes available of these tube cutters
||5/8" O.D. TO 1 1/2"
|Models available of these tube cutters
||ATP-625 TO ATP-1500
Tube Cutter Drives with Self Feed
|Models Available of these tube cutters drives
||TIC-625, TIC-350, TIC-200,
TIC-100 and TIC-40